ThermaX™ PEI 9085
Dedicated For : Zortrax Endureal, CreatBot F160 PEEK, Creatbot F430, CreatBot PEEK 300
Weight : 0.5kg/ 1kg
Filament Diameter : 1.75 /2.85mm
ThermaX™ PEI 3D Printing Filament, Made Using ULTEM™ 9085 PEI
ThermaX™ PEI 9085 is a premium filament made using ULTEM™ 9085 resin from Sabic. This resin is FAA-approved for FST applications (Flame/Smoke/Toxicity) and meets FAR 25.853 and OSU 65/65 standards.
Benefits of PEI 9085 Include:
• High thermal properties, with a Tg of 186°C
• Inherently flame-resistant with low smoke evolution and low smoke toxicity
• Long-term hydrolytic stability
• Excellent dimensional stability, low heat creep sensitivity, and a very low, uniform coefficient of thermal expansion create highly reproducible part-to-part dimensions
• Exceptional strength and modulus, even at elevated temperatures
• Good resistance to a broad range of chemicals, include automotive fluids, fully halogenated hydrocarbons, alcohols, and aqueous solutions
• Stable dielectric constant and dissipation factor over a wide range of temperatures and frequencies
Typical Applications of ULTEM 9085 PEI:
Aerospace: (FAR 25.853 and OSU 65/65 FST)
Service units, oxygen panels and components, ventilation system components, connectors, cable ducts, latches, hinges, food tray containers, door handles, and interior cladding parts.
Automotive & Transportation:
Cost-effective alternative to metal that is strong enough to replace steel in some applications yet light enough to replace aluminium like throttle bodies, ignition components, sensors, and thermostat housings.
Electronics:
Connectors, MCB components like housings, shafts and levers, hard disk drive internals, FOUPs, BiTS, PCBs, MCCB internals, Plenum devices, LCD projector internals, fuel cell components etc